Tropf Blumat Automatic Drip Kits

It is possible to use up to a maximum of 1 metre of the Drip Tube at any one Probe, allowing the water coverage of the system to be extended by the...

Place a Ceramic Probe into the 1/16 inch Drip Tube in the Drip Watering System where you require a watering point.  Plunged into the plants growing...

Use where you need to insert a Ceramic Probe into the Drip Watering System.  Manufactured from robust black plastic.  Barbed at on all three sides ...

Use where you need to insert a Ceramic Probe into the Drip Watering System.  Manufactured from robust black plastic.  Barbed at on both sides to ho...

Barbed at one side to fit securely into the end of 1/16 inch tube. The Drippers are NOT adjustable - the rate of water is adjusted at the Ceramic P...

Drippers are fitted in the 1/16 inch Drip Tube after it's been past through a ceramic Probe cap. In-line Drippers are barbed at either side to hold...

Manufactured from robust plastic. Barbed at both sides to ensure a tight, secure joint between both pieces of tube. Dimensions: 1½ inch (40mm) long. 

Strong and flexible enough to transport the water over large areas it can be held securely in place with either ¼ inch Stakes (to hold the tube in ...

Manufactured from robust black plastic. Barbed on all three legs to hold the 1/16 inch tube securely in place. Dimensions: 1/16 inch (1.5mm) diamet...

Use where you need to divert water into two different areas.  Manufactured from robust black plastic.  Barbed at on all three sides to hold the ¼ i...

This robust Tank Connector is simple to install. Unscrew the Tank Connector so that you have three separate parts ready to fit:Part A - A 2 inch (5...

Manufactured from robust black plastic. Barbed at either end to hold the ¼ inch tube securely in place. Dimensions: 1 inch (4cm) long. 

For fitting to an externally threaded Tap: The Pressure Reducer simply screws onto a ¾ inch / 19mm screw threaded tap. If your tap is a different ...

Manufactured from robust black plastic. Barbed at either end to hold the ¼ inch tube securely in place. Dimensions: 1.5cm long in either direction. 

Suitable for use with the Tropf Blumat Probes ONLY. Learn moreThe Tropf Blumat Drip Watering System. Controlled, Automatic Drip Watering.

Simply push the ¼ inch / 6mm tubing into the top section of the stake.  Sink the 3 inch / 9cm spike of the stake into the ground. This enables you ...

Fitting to the Hose :Fit the Gardena Snap-On Hose Connector to the end of your existing ½ inch / 13mm hosepipe.Into the top of the Pressure Reduce...